This is for ONE resistor.

Solves most LED turn signal problems such as hyper flashing, no flashing or burnt out bulb indications.

You Get: 
1 prewired 6 Ohm, 50 Watt load resistor, and 2 gel filled Splice Taps.
 

-Connect one across each LED turn signal bulb to simulate filament bulbs. One resistor is required for each turn signal bulb.

Connection Instructions
Using included splice taps, connect one wire to ground and the other wire to the turn/brake wire. You do not have to cut your car's or bikes wiring. Squeeze splice taps. One Load Resistor required for each turn signal bulb. No instructions are included with these kits.

 Load Resistors can get very hot so please do not mount directly on plastic!